|
Intermatic
Pool and Spa Time Switches,
Time Control
Clocks with freeze protection
Model PF1103T Freeze
protection Control is self-contained in an indoor-outdoor,
beige, rainproof enclosure and designed to automatically control
as well as protect pool and spa equipment and plumbing against
freeze damage. The control, if wired according to instructions,
turns ON/OFF the Filter Pump on a daily schedule and also
turn ON the Filter Pump when the air temperature (where this
Control is located) drops below the temperature set by the
thermostat dial (between 32 F and 45 F). Nevertheless, the
control is not intended to be a substitute for insulation,
covering or maintenance.

PF1102T
w/ mechanical clock
| Intermatic
single circuit switch w/freeze models |
|
| - PF1102T
240v, metal, freeze, 3.0 HP |
|
| - PF1103T
120/240v, metal, freeze, 1.5/3.0 HP |
|

PF1103T
w/ digital clock
Model PF1102T is
designed to operate either on 240 volts, 60 cycle and Model
PF1103T is designed to operate either on 120 and 240 volts,
60 cycle. when used on 240 volts however, the neutral wire
must be installed and is not recommended for controlling 240
volts GFCI protected equipment. For such application, use
Model PF1102T Time Control with Freeze Protection.
CASE
- The PF1102T
and PF1103T
versions are rated for NEMA 3R indoor/outdoor installation.
0.034" drawn steel 9-3/8" (23.8 cm) high, 5-1/2"
(14.0 cm) wide, 3.5/8" (9.2 cm) deep in beige finish.
Bracket plus 2 holes below switch on back for mounting. "P"
models are the same as above, except made from outdoor grade
plastic.
Knockouts
- Combination 1/2" - 3/4" nominal knockouts, one
on back and each side of case, and two on bottom.
Electrical
Rating - Suitable for pool and spa equipment control
with input voltage of 120 volt - 60 Hz Or 240 volt - 60 Hz,
Electrical Rating of 1.5 HP - 120 volt AC, 3 HP - 240 Volt
AC.
Shipping
Weight - 3.75 lbs. (1.7 kg) Agency Approval
- CSA/C-US


The PF1102T
and PF1103T
time Control with Freeze Protection is designed to
automatically control as well as protect the pool/Spa equipment
and plumbing against freeze damage. The Control, if wired
according to instructions, turns ON/OFF the Filter Pump on
a daily schedule and also turns ON the Filter Pump when the
air temperature (where this Control is located) drops below
the temperature set by the thermostat dial (between 32°
F and 45° F). Nevertheless, the control is not intended
to be a substitute for insulation, coverings or maintenance.
It is self-contained in an indoor-outdoor, beige, rainproof
enclosure and designed to operate on 240 Volt, 60 cycle only.
Model PF1102MT is a mechanism only, functions just like Model
PF11 02T and fits (snaps into) any Intermatic Pool Panel,
Models T10000R, T30000R or T40000R Series.
|