After Removing the impeller, remove the four bolts that secure
the seal plate to the pump motor. Pay extra attention to the orientation
of the seal plate on the pump motor. Seal plate has marks that show
which side is top and bottom. Clean and debris and rust that may
have accumulate in this area. Place the seal plate on top of a piece
of cloth with the side that was connected to the pump motor facing
up and the pump seal facing down.
Caution: If the pump is old, it may have hard water deposit
and rust that can make it difficult to remove the bolts that secure
the motor to the seal plate. Use rust remover or scale removal solutions
to loosen bolts. If you use force to remove bolts you may strip
the threads on the seal plate.
WhisperFlo pool pump Parts
you need to rebuild your Pentair WhisperFlo pump?
we have a convenient and affordable solution with every part needed
to rebuild your pump packed in one kit:
Pool Pump wiring conduit with 4-wire conductors, elbow
Make installation of a pump easy and safe with this 4-wire
6 ft. electrical conduit built with heavy-duty all-weather
material for outdoor installation. Includes metal elbow
and nipple to make connection to any pump very simple.
Aladdin MagicLube #631 Lubricant
for o-rings, bearings PTFE based 5 oz. for pool and spa
Praher CPVC coupler with O-ring
2" SLIP x SLIP for pump and heater plumbing
Coupler 1 1/2" SLIP x 1
1/2" MPT for 1 1/2" PVC pipe
CPVC pipe 2" threaded ends
- cut-in-half and use for pump suction/return
CPVC pipe 1 1/2" threaded
ends - cut-in-half and use for pump suction/return
Check Valves: When two or more pounds of water pressure
is applied the spring-loaded gate opens. The valve relys
on a small internal spring to close the disc whenever water
is not moving in the intended direction.